Many factors affect knots including: the appropriateness of knots and rope materials used in particular applications, the age, size, and condition of ropes; and the accuracy with which these descriptions have been followed. The only trick is to use Palomar knot to tie a hook to a line so it stays in 90 degree angle to a line with the hook pointing upwards.
The knot made by steps 7 and 8 is the overhand knot. If you tie it correctly without crossing your lines, you will never have an issue with this knot. So the longer you make your tag end, the longer leader length you’ll have between your hook and weight. Many depictions of this knot elsewhere make it look like the loop part of the knot goes up against the bottom of … It is regarded as one of the strongest and most reliable fishing knots. You’ll give your drop shot a different look which may result in a few more bites on your next trip to the lake.“The knot itself is really simple,” Scroggins said. The loop is then passed over the hook and tightened around the bight below the eye. It can be used for casting out from the shore as well as … Tying it: After the loop is passed through the eye, an overhand knot is tied with the loop. In this video, I illustrate not only how to tie a correct palomar knot with fluorocarbon fishing line, but also how the palomar knot often gets tied incorrectly leading to break-offs on the hookset. Next, thread the line back through the eye and leave room for 6 inches on both sides. Be sure that when the hook or lure is passed through the loop that all parts of the knot cinch up together. “Just make sure you use a long tag end when tying this knot on a drop shot. The Drop Shot rig is simply a rig where the weight is at the terminal end of the line and the hook is tied with a Palomar Knot above that weight at the distance desired.
“I use a 5 ft length fluorocarbon leader and attach the hook with a Palomar knot, leaving a tag end of around 2 ft. “I then clip on a purpose-made dropshot weight on the tag end.
The best hooks for drop shot rigging are sizes 1 and 2 though you can do it with hook sizes ranging from 2/0 to 6. Where failure could cause property damage, injury, or death, seek professional instruction prior to use. In this video, Kevin goes in-depth regarding the drop shot rig and its importance in nearly every kind of water and condition. This power-fishing success led him to experiment with this knot for drop shotting, too.“It gives the bait a more lifelike presentation,” Scroggins said. As more top finishes were notched by anglers employing the technique, however, public acceptance also increased. It’s basically a hook with the soft plastic lure tied to a main line or rig with the weight on the bottom of the rig. Thread the tag end of the leader into the eye on the top of the hook, so that you have 6–8 in (15–20 cm) of line to work with. To tie a Palomar knot, start by holding a fish hook vertically with your thumb and pointer finger, threading some line through the eye, and pulling 12 inches of line through. “The knot itself is really simple,” Scroggins said. “Just make sure you use a long tag end when tying this knot on a drop shot. Most anglers were slow to adapt to drop shots when they were first introduced. Then, use a palomar knot, swivel knot, or uni knot to secure the hook to the leader.